So I’m trying to get my printer to a point where i can pretty consistently turn out high quality prints, but I’m at a point now where i get results like this. These two prints are from the same batch, same print job, and I’m completely clueless on how to fix it. I have an ender 3 v2 with a bltouch, I’ve adjusted the eccentric nuts, tightened the belts until the tips of my thumb and index finger couldn’t tighten them any further, bed is level, using hatchbox pla. I know i can do ironing to fix the cosmetic problem, but I’d prefer to fix the root issue if possible.
Jesus Christ just throw it away and buy a real printer.
Sorry, just because you’re not capable enough to work with something that wasn’t completely fine-tuned for you at the factory doesn’t mean many of the rest of us have any problems with these machines. I do manual bed leveling and I can walk away from my printer for a year, turn it on, and pop out as good of print as the previous time it was used. How well does your “real” printer work after a year of neglect and with all the fancy gizmos turned off?