do not microwave

Nextcloud News - the Nextcloud RSS reader

Thanks for sharing. I would also be interested if this reflects Lemmy. 1% would be higher than I suggested to be honest.

Over here: https://veloren.net/download/

At the moment the best way to find new communities imho.

You might also want to check out the RockChipConsoles community (even if it is still pretty quiet over there).

[email protected]

A community for consoles based around the rockchip processors like Anbernic, Powkiddy or Odroid.

I really loved their sub. What are the best AMA communities over here?

Maybe there are still older files in your installation that cause the errors? Have you tried to completely remove it?

Since its a webapp it uses your mobile browser. So maybe another browser would work better.

Used Jerboa but switched to wefwef on mobile and it’s the best mobile app imho at the moment.

There is an extra icon for cross-posting

I don’t know why this keeps happening! argh!

Ah! My device is still on 12+ and there is no official support for 13+

If I understood correctly Lemmy 0.18.0 contains breaking changes which need an adoption for current clients to work. Since I’m pretty sure that most instances will upgrade asap that step was necessary.

Wow! That’s awesome! What additional modifications were needed?

Haven’t seen much about this project nor if it will be open-source. But it looks at least promising and I really loved Apollo in the past.

I think any good alternative client that can use the current momentum of kbin/lemmy is good.

Even more since Jerboa is afaik developed by one of the two main devs of lemmy and they will probably/hopefully focus more on the core development and I doubt that they can maintain an additional mobile app at the same time.

I’m not related with the project. Just wanted to share that information that popped up in my timeline.

Here is her signup for the private beta: Beta signup

Ok, sharing mastodon posts isn’t as easy as I thought 😅

For the eSUN PLA+ I’m using 210°C for all layers and a consistent bed temp of 60°C.

Still using a 0.4 nozzle and a 0.2 layer height.

That’s really strange.

What’s the temperature you are printing the eSUN PLA+ filament? Maybe it’s too low and the noozle scratches on the print?