I’ve been repairing a Creality CR-10S Pro V2 and can’t figure out this persistent oddity. It prints spiral vases and benchies flawlessly, but regular 3D prints often have these pronounced bumps and thick whiskers sticking out. I think it’s more than just Z seam blobs, I’m wondering if it’s an issue with the wipe settings not working well in PrusaSlicer…

Here’s another example of the issue: https://i.imgur.com/ZHssQWI.jpg

I’m using Kaaber transparent PETG, printing at 215/210 nozzle and 75 bed. I know this seems cool for PETG, but this brand tends to melt and ooze at anything hotter.

Here are my PrusaSlicer retraction settings, they are the default for this printer:

https://i.imgur.com/RqrltUL.jpg

I tried slightly bumping the retraction to 6.5mm and 65mm/s, but it made no difference.

Any ideas what would cause this? I’m getting it while trying to print many parts of the honeycomb storage wall off printables.

  • wizzor@sopuli.xyzEnglish
    4·
    1 year ago

    I would try with another slicer to be safe. I trust you have cleaned your nozzle too?

    • poofy_cat@lemm.eeOPEnglish
      1·
      1 year ago

      I’ve tried this with 0.6 and 0.4 nozzles, both had the same issue. And I make sure they are clean to start. I’ve also replaced the bowden tube and extruder, both of which didn’t improve this hah.

      • wizzor@sopuli.xyzEnglish
        1·
        1 year ago

        Any chance there is moisture in the filament? I know I’m grasping at straws here…